Closet Shelving Ideas for Pantry

Apr 15th

Closet shelving ideas – organized pantry can make the meal variety less of a planning nightmare and the preparation less challenging, for housewife or professional chef. The basic rule is that you can never have too much shelf storage.

White Wood Closet Organizers
White Wood Closet Organizers

Instructions

12 Photos Gallery of: Closet Shelving Ideas for Pantry

Image of: White Wood Closet Organizers
Image of: Traditional Wood Closet Organizers
Image of: System Closet Drawers
Image of: Renovation Wood Closet Organizers
Image of: Minimalist Wood Closet Organizers
Image of: Kids Wood Closet Organizers
Image of: Easy Closet Ideas
Image of: Design Closet Ideas
Image of: Corner Closet Drawers
Image of: Complete Closet Ideas
Image of: Closet Ideas Storage
Image of: Classic Closet Ideas
 

Measure to the height of the shelf with a measuring tape, from the floor surface. Connect the two brands, using a level to ensure that the line is straight and level. This will be the position of the rear shelf support card. Extend a level horizontal line about 12 inches from both ends of the line marked in step 2. Run a rule detector along the lines marked in steps 2 and 3, making a small pencil line in the middle of each stud position just above the horizontal pencil line. These marks will help to attach support boards to the wall.  Measure the horizontal dimension of the line marked in step 2 and cut a piece of 1-by-2 pine to this length.

Hold the 1-by-2 pine support on board cut in step 5 flat against the wall, with the top edge aligned with the horizontal line marked in step 2, and attached to the wall with a hammer and two vertically positioned 8d surface nails on each bolt location marked in step 4.  Measure two 1-by-2 pine than support boards to 10½ inches long. Cut a length of 1-by-12 numbers to hat shelf support length is determined in step 5 minus? Inch, then place it horizontally on top of the shelf support boards installed in steps 6 and 7. Press the 1-by-12 shelf board tight to the rear wall and attach the support boards with 6d surface nails about 10 inches apart.

Leave a Reply

Your email address will not be published. Required fields are marked *